How To Count Points On A Deer

How To Count Points On A Deer. There are three ways of counting the points on a rack. This is in fact, your first area to start counting points with.

Can you count the points on this buck? The Hull Truth from www.thehulltruth.com

You can measure their width, you can score them using the boone and crockett method, or, the most common method, you can count the points. You will need to start by measuring every protrusion from the base where they are attached to the main beam to their tips. Hunters there count all the points on a deer's antlers and add them up.

There Are Three Ways Of Counting The Points On A Rack.

Align the line at the base of the main point where it connects to the main beam. Placing the cable down the center of the main point, measure the point and count it if it is longer than one inch. This is basically the spot where they stay fixed to main beams with their tips.

The Total Number Of Points Are Counted For White Tail Deer, For Mule Deer Or Elk You Count The Points On One Side If They Are Even.

If the protrusion measures more than an inch, count it as a point and record it. Main beams’ end tips are points. You can measure their width, you can score them using the boone and crockett method, or, the most common method, you can count the points.

If It Measures At Least 1 Inch In Length From The Main Beam, It Is Counted As A Point.

This is in fact, your first area to start counting points with. On the antler’s main beams, each tip will be qualified as a point for counting. Any protrusion that you find to measure more than an inch from the main beam qualifies as a point, and you should record it when counting the buck’s points.

There Are Several Different Ways To Rate The Quality Of Deer Antlers.

A typical mule deer is four points on one side with brow tines. How do you count deer points? Hunters there count all the points on a deer's antlers and add them up.

Measure Each Protrusion From The Area Where It Leaves The Main Beam To Its Tip.

Tine lengths, while they may seem easy, are actually quite difficult to estimate. You will need to start by measuring every protrusion from the base where they are attached to the main beam to their tips. Not all protrusions qualify as points, and there is a recognized system for determining what constitutes an antler point.

Tags: ,

Leave a Reply

Your email address will not be published.