How To Reset Honeywell Thermostat Th3110D1008. Wait 5 minutes for the system to respond. Flip the circuit breaker controlling the circuit.
Remove the wallplate from the thermostat by pulling from the bottom, then follow directions below for mounting. Dimensions (in.) 3 13/16 in. 2 push excess wire back into the wall opening.keep wires in shaded area as shown at left.
Table of Contents
Remove The Thermostat From The Mounting Plate.
Set system switch to heat (see page 3). Your honeywell thermostat is back to normal. In order to calibrate a honeywell digital thermostat, check the thermostat's accuracy with a tube thermometer, make sure the thermostat is clean inside the face plate, and make sure that the thermostat is level with the ground.
A Faster Way To Reset A Honeywell Thermostat Without A Reset Button Would Be To Switch Off The Circuit Breaker’s Power.
So, how to reset a honeywell thermostat? Here’s how to factory reset some of the most popular honeywell thermostat models. Wait 5 minutes for the system to restart safely, without damage to the compressor.
To Restart Safely, Without Damage To The Compressor (See Page 8).
The thermostat can be powered by batteries alone or,if used with ac power,can provide backup power to the display during power interruptions. Wide x 1 1/4 in. Also works with millivolt systems.
Align The 4 Tabs On The Wallplate With Corresponding Slots On The Back Of The Thermostat, Then Push Gently Until The Thermostat Snaps Into Place.
Mount thermostat and restore electrical power wallplate tip: High x 5 3/8 in. Make sure the temperature is set higher than the inside temperature.
1 Heat/1 Cool Conventional Systems And Heat Pumps With No Auxiliary Heat.
Press [symbol] until you see reset, and then select it. Flip the circuit breaker controlling the circuit. Remove the wallplate from the thermostat by pulling from the bottom, then follow directions below for mounting.